Description
Supplied with:
- Connection union
- Pre-wired Hydrogenie 4.1 or 5 controller
- Base mount plate
- Pressure tank
- Pre-wired and tested
Controller Features:
- Max pressure: 8Bar.
- Operating temperature range: -0 to +60ºC.
- Connection Thread: 1 1/4” male.
- Minimum pump pressure: 1.0Bar.
- Motor overload protection – adjustable.
- Start pressure adjustable from 0.5 – 7.0bar.
- Stop pressure (if in Pressure dependent mode) adjustable 1 to 8bar
- Automatic reset/restart following run dry: If the pump runs dry the controller will attempt to re-prime after 5 minutes. consecutive attempts are performed every 30 minutes.
230v Single phase or 400v Three Phase
Max 10A rated (per phase)
Max 10bar rated
Motor overload and run dry protection with auto restart function
Over and under voltage protection
Short between phases protection
Start pressure range 1-5bar (on/off mode)
Max start pressure 6.5bar (pressure dependent mode)
Max stop pressure 7 bar (pressure dependent mode)
IP55 protection
Adjustable start and stop delay
Instantaneous digital screen displays: Line pressure, set pressure, Amp draw, Flow sensor position, controller temperature